|
Success
|
|
|
Supported for Notification Lists and the Notification Queue only. If there are Down Device Notifications in a single processing cycle. Send only one Email to Notification List repipients for all Devices.
|
|
|
If a large influx of Down Device Notifications come in, Cacti can pause sending out those Notifications for a certain period of time to see if the issue is transient before sending them out. Select the threshold Down Device Notifications before the Pause is Triggered.
|
|
|
If you choose to delay Notifications for a large Down Devices Notification inrush, how long are you willing to wait before allowing the notifications to be processed?
|
|
|
Enabled at Template Level
|
|
|
A Threshold must be enabled both at the Template Level and the Threshold level to be checked.
|
|
|
The Threshold Type. For Baseline Types: [TIP] refers to the Time In the Past with MIN, MAX, AVG, and LAST from no more than a day in time from that period. [AOT] refers to the Average over the entire Time period. If there is a colon followed by MIN, MAX, AVG, LAST, the Value came from that Consolidation Function.
|
|
|
The type of Baseline. [TIP] is the Time in Past, [AOT] is the Average over Time. Percentage Deviation is a percentage value from the historical value. Absolute Value is a deviation either above or below the Baseline over that historical value. For the [TIP] Baseline Types, the MIN, MAX, AVG, and LAST will come from no more than a one day time period at that point in time.
|
|
|
Consolidation Function
|
|
|
The Graph End time will be set at the time of triggering. The Graph Start time will be the End Time minus the Graph Timespan.
|
|
|
Minimum
|
|
|
Maximum
|
|
|
The Consolidation function to use for the Baseline Type value calculation.
|
|
|
Check this box if you wish Warning Notification List recipients to receive Alert Emails in addition to the Alert Notification list receivers. This case is applicable when Warning Notifications goes to Administrators and Alert Notifications go to Management.
|
|
|
Force Units Suffix
|
|
|
If you wish to display a forced unit suffix on the various Threshold pages and Notifications, enter it here. The size is limited to no more than 10 characters.
|
|
|
Decimal Digits to Display
|
|
|
The number of decimal digits to display for Threshold and Current Values. The default is auto or 2.
|
|
|
Checking this box will enable Threshold Daemon debug when operating from SystemD or through the command line. This change is dynamic and will take effect as soon as the next Threshold loop commences.
|
|
|
Daemon Threads
|
|
